Low frequency rumble sound effects isolated from passing traffic in the 0-500Hz range, featuring quakes, tremors, rises, hovers, swells, and pitch bends recorded at 192kHz with Sennheiser and Sanken microphones.
I’ve lived in houses near busy roads. Cars driving by at all hours of the day…. Pass Bys… Vehicle Revs, Engine Rumbling, etc etc etc…..Ruining perfectly good recordings. But this time, it’s used to our advantage. All recordings are made during sound effect record sessions. Instead of removing unwanted car sounds, they are amplified, isolated, gained up, increased level.
All recordings range from 0-500Hz and can be used to create organic, real drone like sounds. Rumble, Tremble, Quake, Shake, Sci Fi, Pitch Bends, Rev, Resonates, Trembles and more. Use as a layer in a drone, vehicle, LFE/Subwoofer channel, and whatever else comes to mind. So buckle up and listen carefully, put on your best headphones or listen on your best speaker system.
Disclaimer: Be cautious, these sounds have extreme high volumes in the lower frequencies. Please take care, don’t listen too loudly.
Exterior Rumble Inside uses no special processing other than EQ, adjusting gain, and using iZotope Rx to assist in selecting frequencies to adjust.
These sound files were recorded at 32bit, 192kHz using the Sennheiser MKH8050, Sennheiser MKH30 and Sanken CO-100K microphones into a Sound Devices Mix Pre-10ii.
All are metadata tagged using the Universal Category System in Soundminer, and also searchable in Soundly, and Basehead.
